[Shadowrun]
Post Apoc Gangers

We are currently preparing to revive a RPG from our youth: Shadowrun 2.01D. In preparation, I ordered a bunch of 15mm miniatures to use in the skirmishes.

These Post Apoc Gangers are from Rebel Miniatures. After cleaning them, I mounted them on washers for magnetic storage.


[Shadowrun]
Post Apoc Raiders

We are currently preparing to revive a RPG from our youth: Shadowrun 2.01D. In preparation, I ordered a bunch of 15mm miniatures to use in the skirmishes.

These Post Apoc Raiders are from Rebel Miniatures. After cleaning them, I mounted them on washers for magnetic storage.


[Shadowrun]
Modern Civilians

We are currently preparing to revive a RPG from our youth: Shadowrun 2.01D. In preparation, I ordered a bunch of 15mm miniatures to use in the skirmishes.

These Modern Civilians are from Rebel Miniatures. After cleaning them, I mounted them on washers for magnetic storage.


[Shadowrun]
Men-In Black

We are currently preparing to revive a RPG from our youth: Shadowrun 2.01D. In preparation, I ordered a bunch of 15mm miniatures to use in the skirmishes.

These Men-In Black are from Rebel Miniatures. After cleaning them, I mounted them on washers for magnetic storage.


[Shadowrun]
Irish Hitmen

We are currently preparing to revive a RPG from our youth: Shadowrun 2.01D. In preparation, I ordered a bunch of 15mm miniatures to use in the skirmishes.

These Irish Hitmen are from Rebel Miniatures. After cleaning them, I mounted them on washers for magnetic storage.


[Kickstarter]
2000AD: Rogue Trooper Miniatures Game

The staff car arrived.

Only the rules are missing now:

  • 3 Rogue Troopers
  • 2 Souther Soldier sets
  • 4 Nort Soldier sets
  • 2 Nort and Souther Officer sets
  • 1 Souther Staff Car
  • 1 Rulebook ✖

[Song of Fork and Heroes]
Agyptian Temple

According to the building instructions from Hirst Arts, this is the rear center wall.

Which does not look right to me. So I changed it to the same top pieces as the rest. Here is the completed enclosure with the roof not glued in place (the top of the colum is still missing).

I again used a 5mm MDF base, bevelled the edges and strengthened them with filler. Then I applied acrylic caulking and spread it out in a thin layer.

This was the base for me using a Textured Green Stuff World Roller Pin for the first time. I used water to wet it, which was too much, made the acrylic too soft and took away too much material. But as I only wanted to have the pattern show through sand here and there this was fine.

On the still not cured acrylic caulking I placed the temple as well as four pillars with torches on top.

When everything was dry, I marked the width of the entrance to place some steps leading to it.

Then the base was sanded.


[Song of Fork and Heroes]
Agyptian Watchtower

The third and last Agyptian building I was casting for is a watchtower, using mainly the Egyptian Tower Mold #93.

The blocks went together well, only for the top of the door I needed to modify some of the blocks. The instruction says to sand the back of the decorative blocks to the angle of the wall, but I found it more easy to attack the wall.

Ground level done. This will remain one large, big, high room, here the supplies are stored, and horses can be sheltered. I glued the blocks, so that on the outside there is a row of glyps running up the center.

This is how the first level will look like, having two windows each side.

I ran out of some blocks (the smallest for example) and have to cast some more now to continue construction.


[Song of Fork and Heroes]
Agyptian Temple

The parts are mostly done. I need to do two more castings to finish them.

I again use a 5mm MDF board for a base and bevelled the edges.

The edges were then strengthened and sealed with filler.


[15mm]
Corporate Marines

The command car is done.